Accessories for Laser Beam Analysis - Filters

In the case of  M^²Beam and FocusGage systems, filters can be inserted between the knife-edge and the sensor, this specific arrangement will prevent the attenuation from distorting the beam since it is behind the scanning plane.
The general guideline for use is as follows:

• No filter : Power up to 5 mW
• NG4 filter: Power up to 50 mW (~10% transmission)
• NG9 filter: Power up to 1 W (~0.5% transmission)

In the case of  BeamOn system, three filters are provided in housing, 1.6 mm thick Schott colored filters. Filter type include: NG4, NG9 and NG10.
The general guideline for use is as follows:

• NG4 filter: Power up to 50 mW (~10% transmission)
• NG9 filter: Power up to 1 W (~0.5% transmission)
• NG10 filter: Power up to 1.5 W (~0.5% transmission)

Accessories for BeamOn system

A special attachments for high power lasers attenuation up to 100 W/cm².

SAM1 - beam sampler with a sampling range 3x10^-3 from 350nm - 1100nm.  
SAM2 - beam sampler with a sampling range 1x10^-6 from 350nm - 1100nm. 
RDC - beam reducer with factor of 1x2.0 at the visible range. 

               SAM1                                  SAM2                                          RDC

SAM3 - reflective beam sampler for our line of high-power Beam Profilers and Beam Positioning systems. This is a polarization preserving beam sampler with sampling reduction factor of 0.0016 Average, over a wide spectral range (250 - 2000nm)..

                 SAM3

This is a general-purpose attachment that can be used along with the following measuring heads:

• BeamOn
• BeamOn HR
• SpotOn CCD
• Beam Analyzer
• µBeam

Download Brochure
BeamOn Accessaries SAM3